Configuring Enterprise Edge Services 201P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations GuideConfiguring IP RoutingThe followings table shows the Enterprise Edge IP routing protocols and theprecedence order when conflicting or redundant routes occur.IP Routing global settingsTo configure global settings for IP Routing:1. Choose Services and click the IP Routing heading.The IP routing Summary, RIP Global Settings and OSPF Global Settingsconfiguration screens appear.2. Configure the Routing Summary attributes according to the following table:3. If your network uses RIP, configure the RIP Global Settings according to thetable below. If your network uses OSPF, go to step 6.The RIP Global Settings are:Precedence IP Routing Protocols1. Static Routing2. OSPF3. RIP v1 and v2Attribute DescriptionDescription Shows a description of the router.Version Shows the version of the router.Status Allows you to enable or disable the router. The possible values are:Up: the IP router is currently functioning.Enabled: allows you to enable the router.Disabled: allows you to disable the router.RIP Log Level Allows you to enable the recording of events in the Event Viewer. Thefollowing options are available:Maximum, logs all information in the Event Viewer.Warnings Also, logs errors and warnings in the Event Viewer.Errors Only, logs errors in the Event Viewer.Disabled, disables event logs.The default value is Errors Only.Triggered UpdateIntervalAllows you to specify the minimum interval, in seconds, at which a routermust send a routing table update if the metric for a given route changes. If therouter detects a change in the routing information, the router sends an updatemessage at the specified interval.Possible values are 1 to 50000.The default value is 5.
