Configuring Enterprise Edge Resources 77P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide2. Change the mapping that is applied to incoming calls of this service type toobtain the received digits. In all cases, the received digits are used to find atarget line or to activate Remote Access.None: No mapping is applied. The last ‘N’ digits of the Called Party Numberare used as received digits. Note that if there is no called party number (mayoccur with some FX calls) the call will ring at the incoming trunk’s Prime set.All: Lets you define the received digits used for all calls with this servicetype, regardless of the called party number or service identifier (SID). For thisoption, all calls with this service type on this PRI will ring the same targetline.Map table: Lets you associate different received digits with different calls ofthis service type depending on the call party number and/or the serviceidentifier. Incoming calls that do not match any entry defined in the map tablewill ring at the prime set. Depending on the service type and the protocol, youmay be able to map the called party number (By number) and the serviceidentifier (SID). The following table shows the different options.Note: This setting is available for T1 trunks configured as T1 E&M. See Trunk/line data on page 111 for more information about configuring trunk types.T1 Parameters (North America only)The T1 Parameters heading appears for card types that have been configured as T1or PRI. It lets you define a number of settings that are dependent on your T1 serviceprovider settings.To program T1 Parameters:1. Choose Resources, Media Bay Modules, Bus 02-07, Modules on Bus,Module 1, and T1 Parameters.ServiceProtocol FX 800 I-800 SDS 900NI-2 SID By number N/A N/A N/ADMS-100 SID SID or By number N/A N/A N/ADMS-250 SID SID or By number N/A N/A SID or By number4ESS N/A By number By number By number By number