Oce 9400-I User Manual

Also see for 9400-II: User manual User manual

Contents

22 Océ 9400-II User ManualConnect the printer to your hostenvironmentThe Océ 9400-II supports several types of interfaces (Centronics, Ethernet 10& 100 Mb/s, TCP/IP). Novell and Ethertalk are supported through the optionalprint server.To ensure proper operation, please follow the steps below when connectingyour host to the Océ 9400-II.1 Make sure that both the host and the Océ 9400-II are turned OFF. See‘Centronics’ on pa ge23 or ‘SCSI-2’ on pa ge25.2 Connect the appropriate interface cable to your local host and thecorresponding interface connector to the Océ 9400-II (see ‘Centronics’ onpage 23 or ‘SCSI-2’ on pa ge25).3 Turn on the Océ 9400-II (see ‘Centronics’ on pa ge23 or ‘Ethernet’ onpage 27).4 Enter the Program mode to configure the connection parameters (see‘Centronics’ on pa ge23, ‘Ethernet’ on page 2 7 or ‘SCSI-2’ on page 2 5 ).5 Enter Program mode to configure the Océ 9400-II to meet your requirements(see ‘Printing files’ on page70 o Customizing the printer’ on pa ge79).6 Exit Program mode. If applicable, install and configure the appropriate hostsoftware on your local host environment.7 Turn the printer OFF and then ON again.Note: When specifying connection settings, you must switch the printer Off andOn again to activate your new parameters. Tip: configure all settings at thesame time, then turn the printer Off and On.