Oce 9400-I User Manual

Also see for 9400-II: User manual User manual

Contents

Copy jobs 63In standard cut mode, the copy is cut at a standard format (portrait). You selectthe width of the standard format with the ‘up’ or ‘down’ button.Example: selecting 36 inches means that you select a 36-inch width formatand a corresponding 48-inch length. The material is cut to a length of 48 inchesregardless of the roll width.Note: Depending on the ISO, ANSI or ARCH range specified, you get the papersizes displayed in the corresponding column (see ‘Order of standard sizes forusing standard cut’ on p a ge138).If you make adjustments in standard mode using the cut button, the standard’indicator above the button flashes. After confirming the standard selection, theindicator remains on. Confirm the setting by pressing the zoom, edge, cut,media or start buttons.When standard cut is selected, the system always cuts at the selected length. Itdoes this even if the actual length of the original is shorter or longer than theselected length (taking into account the zoom factor and the leading/trailingedge setting). Selecting synchro or standard cu1 Press the ‘cut’ button to select the cut mode you want. The selected cut mode'sindicator will light up.If you select standard cut:2 Press the ‘up’ or ‘down’ button’ to select the required cut length.The required length is shown in the operating display. Confirm the setting bypressing the zoom, edge, cut, media or start buttons.For an overview of the possible standard lengths, see ‘Order of standard sizesfor using standard cut’ on pag e138.