8.[Administration] Tab Page[Setup] Item List 1418 [Administration] Tab Page Setting up SNTP ServiceIn SNTP Service, you can specify the SNTP server to refresh the time settings of this equipment using SNTP service. Setting up Daylight Savings Time SettingMake the required settings for daylight savings time.y If you change the settings during the daylight saving time period, the changes will be reflected to the equipment'sclock. If you disable the settings during the applicable period, the equipment's clock will shift to the standard time.y If the equipment is turned off at the start or end date and time, the equipment will shift the clock the next time it isturned on.y After the clock shifts, the daylight saving time will also apply to the weekly timers.Item name Description1 Enable SNTP Select whether to enable or disable SNTP (Simple Network Time Protocol). When this isenabled, the time settings of this equipment can be adjusted using the SNTP service.[Date & Time] settings are not available if enabled.2 Primary SNTP Address Enter the IP address or FQDN (Fully Qualified Domain Name) of the Primary SNTP ServerAddress when [Enable SNTP] is enabled.3 Secondary SNTP Address Enter the IP address or FQDN (Fully Qualified Domain Name) of the Secondary SNTPServer Address when [Enable SNTP] is enabled as required.When the [Obtain a SNTP Server Address automatically] option is enabled in the TCP/IP settings, the SNTP server addresscan be obtained using the DHCP server.P.143 “Setting up TCP/IP”4 Scan Rate Enter how often this equipment should access the SNTP server to check the time.5 Port Number Enter the port number for the SNTP service. Generally "123" is used.6 NTP Authentication Select whether to enable or disable NTP authentication.Item name Description1 Daylight Savings Time Select [Enable] to shift the clock to the daylight savings time. [Disable] is set as the default.2 Offset Select the desired offset (time difference) from the local standard time. You can select frombetween -2 and +2 hours, excluding 0 hour, in 30-minute increments. [+1:00] is set as thedefault.3 Dates Select the applicable period for the daylight savings time.y Start — Select or enter the start date and time of daylight savings time.y End — Select or enter the end date and time of daylight savings time.123456123
