8 [Administration] Tab Page148 [Setup] Item List Setting up IPX/SPXYou can set the IPX/SPX protocol to enable the communication over IPX/SPX. The IPX/SPX must be configured to enableNovell printing with NetWare server 5.1, 6.0, 6.5 over IPX/SPX.5 Use Stateless Address Use the IPv6 addresses (Stateless addresses) issued from routers.y Use DHCPv6 Server for IP Address(M flag) — Use the IPv6 address issued from theDHCPv6 server in the stateless network environment.y Use DHCPv6 Server for options(O flag) — Use the optional information (IPv6 addressfor the DNS server, etc.) issued from the DHCPv6 server in the stateless networkenvironment.y FQDN Option — The FQDN option is available if Use DHCPv6 Server for IP Addressis selected. Select [Server] or [Client] for [Update Method] if using the FQDN option.[Server] is set as the default.y IP Address — Stateless Addresses obtained from routers are displayed. Up to 7 IPv6addresses can be retained.When this equipment receives a router advertisement (RA) from a router, of which M flag configuration is "0", the DHCPv6function is disabled. If you change a router advertisement (RA) M flag configuration from "0" to "1", it is necessary to rebootthis equipment to enable the DHCPv6 function.6 Use Stateful Address Use the Stateful address issued from DHCPv6 server.y Use DHCPv6 Server for IP Address — Select whether or not the IPv6 address whichis issued from the DHCPv6 server is used for this equipment.y Use DHCPv6 Server for options — Select whether or not the optional information(IPv6 address for the DNS server, etc.) except the IPv6 address for this equipment,which is issued from the DHCPv6 server is used on this equipment.y FQDN Option — The FQDN option is available if Use DHCPv6 Server for IP Addressis selected. Select [Server] or [Client] for [Update Method] if using the FQDN option.[Server] is set as the default.y IP Address — A stateful address, Prefix Length and Gateway obtained from DHCPv6Server are displayed.Item name Description1 Enable IPX/SPX Select whether the IPX/SPX protocol is enabled or disabled. Enable this when configuringNovell printing over the IPX/SPX network.[Disable] is set as the default.2 Frame Type Select the desired frame type for IPX/SPX.y Auto Sense — Select this to use an appropriate frame type that the equipment foundfirst.y IEEE 802.3/Ethernet II/IEEE 802.3 Snap/IEEE 802.2 — Instead of [Auto Sense], selectthe frame types to be used from these options.3 Actual Frame Displays the actual frame type of the equipment.Item name Description123
