8 [Administration] Tab Page196 [Setup] Item List Setting up N/W-Fax DestinationYou can configure a network folder to store documents that are sent using the N/W-Fax driver with the Save as file optionenabled. Setting up N/W-Fax FolderIn the N/W-Fax Folder, you can specify in which network folder N/W-Fax documents are saved.10 Retype Password Enter the same password again for a confirmation.Item name Description1 Do not allow any network folder tobe used as a destinationSelect this to not allow any network folders to be used as Save as file destinations for N/W-Faxes documents. When selected, users can only save an N/W-Fax document with theSave as file option enabled to local storage.2 Use Network Folder Destination Select this to allow network folders to be used as Save as file destinations for N/W-Faxdocuments. When selected, set the N/W-Fax Folder settings to specify which network folderto use.Item name Description1 Check box Select the check box so that the popup prompts you to enter the network path or the servername if you try to save the settings without it.2 Protocol Select the protocol for uploading an N/W-Fax document to a network folder.y SMB — Select this to send an N/W-Fax document to the network folder using the SMBprotocol.y FTP — Select this to send a file to the FTP server.y FTPS — Select this to send a file to the FTP server using FTP over SSL.y NetWare IPX/SPX — Select this to send a scanned file to the NetWare file server usingthe IPX/SPX protocol.y NetWare TCP/IP — Select this to send a scanned file to the NetWare file server usingthe TCP/IP protocol.3 Server Name When you select [FTP] as the protocol, enter the FTP server name or IP address where anN/W-Fax document will be sent. For example, to send an N/W-Fax document to the "ftp://192.168.1.1/user/scanned" FTP folder in the FTP server, enter "192.168.1.1" in this box.When you select [NetWare IPX/SPX] as the protocol, enter the NetWare file server name orTree/Context name (when NDS is available).When you select [NetWare TCP/IP] as the protocol, enter the IP address of the NetWare fileserver.4 Port Number(Command) Enter the port number to be used for controls if you select [FTP] as the protocol. Generally "-" is entered for the control port. When "-" is entered, the default port number, that is set forFTP Client by an administrator, will be used. If you do not know the default port number forFTP Client, ask your administrator and change this option if you want to use another portnumber.Item name Description1223451678
