8 [Administration] Tab Page[Setup] How to Set and How to Operate 217[Setup] How to Set and How to OperateThis section describes how to set up the equipment using TopAccess.P.217 “Setting up General settings”P.219 “Setting up Network settings”P.221 “SNMP V3 settings”P.227 “Setting up Copier settings”P.229 “Setting up Fax settings”P.231 “Setting up Save as file settings”P.233 “Setting up E-mail settings”P.235 “Setting up InternetFax settings”P.237 “Setting up Printer/e-Filing settings”P.238 “Setting up Printer settings”P.241 “Setting up Print Service settings”P.243 “Setting up ICC Profile settings”P.250 “Setting up Print Data Converter settings”P.252 “Configuring the EWB function”P.254 “Setting up Off Device Customization Architecture settings”P.255 “Displaying version information”The paper size for each tray cannot be set from TopAccess. Set from the touch panel of the equipment. Forinstructions on how to set the paper size for each tray, refer to the User’s Manual Setup Guide. Setting up General settingsYou can configure general settings such as Device Information, Energy Save, Date & Time, and Web General Setting fromthe [General] submenu under the [Setup] menu.Some settings may not be reflected on the touch panel immediately after saving them. The settings will be updated bypressing the [RESET] button on the control panel or after an Auto Clear time period.Setting the General settings1 Start TopAccess access policy mode.P.22 “Access Policy Mode”2 Click the [Administration] tab.3 Click the [Setup] menu and [General] submenu.The General submenu page is displayed.
