8.[Administration] Tab Page[Setup] Item List 1438 [Administration] Tab Page Network settingsYou can configure the network settings such as TCP/IP, Filtering, IPX/SPX, AppleTalk, Bonjour, LDAP Session, DNSSession, DDNS Session, SMB Session, NetWare Session, HTTP Network Service, SMTP Client, SMTP Server, POP3Network Service, SNTP Service, FTP Client, FTP Server, SNMP Network Service, and Security Service.The [Network] submenu can be accessed from the [Setup] menu on the [Administration] tab.See the following pages for how to access it and information on the [Setup] menu:P.22 “Access Policy Mode”P.136 “[Setup] Item List” Setting up TCP/IPYou can set the TCP/IP protocol to enable communication over TCP/IP. The TCP/IP must be configured to enableTopAccess, SMB printing, Raw TCP or LPR printing, IPP printing, Scan to Email, and Internet Fax.P.143 “Setting up TCP/IP” P.158 “Setting up SMTP Client”P.145 “Setting up Filtering” P.160 “Setting up SMTP Server”P.147 “Setting up IPv6” P.161 “Setting up POP3 Network Service”P.148 “Setting up IPX/SPX” P.162 “Setting up FTP Client”P.149 “Setting up AppleTalk” P.163 “Setting up FTP Server”P.149 “Setting up Bonjour” P.164 “Setting up SLP Session”P.150 “Setting up LDAP Session” P.165 “Setting up SNMP Network Service”P.151 “Setting up DNS Session” P.168 “Setting up Web Services Setting”P.152 “Setting up DDNS Session” P.169 “Setting up LLTD Session”P.154 “Setting up SMB Session” P.170 “Setting up Wake Up Setting”P.156 “Setting up NetWare Session” P.172 “Setting up IP Security”P.157 “Setting up HTTP Network Service”Item name Description1 Ethernet Speed Duplex Mode Select the ethernet speed. [AUTO (-100MB)] or [AUTO] is set as the default.y When you select a specific ethernet speed, you must select the same one as set in the connected network. If you do notknow the ethernet speed that must be used, select [AUTO (-100MB)] or [AUTO].y If the network is not stable, power OFF the equipment then ON.2 Host Name Enter the host name of your equipment. You can enter up to 63 alphanumerical charactersincluding “-” (hyphens).You cannot use a "-" (hyphen) as the first and last character. The MFP name is set as thedefault.12345678910111213
