8.[Administration] Tab Page[Setup] Item List 2038 [Administration] Tab Page Setting up Default Raw Job SettingIn Default Raw Job Setting, you can specify the default raw job setting, which applies to a raw job for which no queuename is specified or for which a specified queue name does not exist.You can also add LPR queue names and specify the raw job setting for each queue.P.204 “Setting up Raw Job Setting”Item name Description1 Raw Jobs - Duplex Printing Select whether a raw job will be printed on both sides of the paper.2 Raw Jobs - Default Paper Size Select the default paper size that applies to a raw job.3 Raw Jobs - Default Paper Type Select the default paper type that applies to a raw job.4 Raw Jobs - Default Orientation Select the default orientation that applies to a raw job.5 Raw Jobs - Default Stapling Select whether a raw job will be stapled.6 Raw Jobs - Default Output Tray Select the default output tray that applies to a raw job. A banner page that is created byNetWare, UNIX, and Windows operating systems also will be outputted to the tray set here.7 PCL Form Line Enter the number of lines printed per page.8 PCL Font Pitch Enter the font pitch when the selected font number represents a fixed pitch scalable font.The font pitch indicates the number of ANK characters per inch. 10 pitch prints 10 ANKcharacters within an inch.9 PCL Font Point Size Enter the font size when the selected font number represents a proportionally spacedscalable font. The Font Size option allows you to determine the point size (height) of thedefault font.10 PCL Font Number Enter the font number of the internal PCL font to be used as the default font for printing. Youcan check the font numbers and internal PCL fonts in the Internal PCL Font List. Refer to theUser’s Manual Advanced Guide for the font number and internal PCL fonts.11 PCL Line Termination Select the type of the line termination.12 Symbol set Select the symbol set that applies to a raw job.13 Paper Source Select the paper source that applies to a raw job.14 Do not Print Blank Pages Select whether blank pages are printed or not.When printing is performed using the UNIX filters or CUPS, this setting is not reflected. If you do not want to print blank pagesin these printings, enable [Do not Print Blank Pages] in the UNIX filter command or CUPS setting. For the setting instructions,refer to the User’s Manual Basic Guide or User’s Manual Advanced Guide.15 Letterhead Print Mode Select whether the last page (odd page number) is printed on the same side as the otherodd-number pages when printing both sides of a Raw print job whose total page number isodd. Select [ON] to print the last page on the same side (back) as the other odd-numberpages. Select [OFF] to print it on the same side (front) as even-number pages.123456789101112131415
