135Connection with external device : Connection with external devices using the USB 2.0 portConnection with external deviceBy connecting AJ-HPX3000 with an external PC using USB 2.0, the P2 card connected to AJ-HPX3000 can be used as amass storage device.1 Connect the USB cable to the USB 2.0 port.Notesz The USB 2.0 cable is not included with the camera-recorder. Please use a commercially available USB2.0 cable (shield with a ferrite core).z It is recommended that the USB cable which iswithin length 3 meters is used.2 Navigate the menu to open the SYSTEM MODEscreen on the SYSTEM SETTING page. Then, set thePC MODE SELECT menu option to USB DEV.and thePC MODE option to ON.NoteThe function of the menu option USB may beassigned to a desired user button by using any one ofthe menu options USER MAIN SW, USER1 SW orUSER2 SW.These options can be found in the USER SW screen,which is accessible from the CAM OPERATION page.Notesz A USB driver must be installed on the PC.z AJ-HPX3000 is only applicable to USB 2.0. Use apersonal computer that supports USB 2.0.z Only one unit at a time must be connected to thePC via USB.z The P2 card must not be removed when it isconnected via USB.z While a USB connection is established, the P2card’s access LED should not be lit except whenaccess is being carried out.z When a USB device is active, recording, playback,or navigation through clip thumbnails is disabled.During a USB connection, the USB LED on the sidepanel stays illuminated. Also, “USB DEVICE” isdisplayed in the system information/warning area inthe viewfinder.When the connection is not correctly established,both of these indications blink.3 There are two ways to terminate the USB mode, asfollows:z Turn the POWER switch of AJ-HPX3000 OFF.z Set the PC MODE item to “OFF” from the menuoperations.Connection with external devices using the USB 2.0 portConnection with a PC in the USB DEVICE modeProcedures for establishing a connection with aPCUSB 2.0 port(DEVICE)# < SYSTEM MODE >SYSTEM MODE :1080i-59.94iREC SIGNAL :CAMCAMERA MODE :60iVF TYPE :HDPC MODE SELECT :USB DEV.# PC MODE :ONWhen you establish the USB connection for the first time,install the accessory P2 software for AJ-HPX3000 on thePC. Refer to the Installation Manual for the details.USB LED # * & & ( ' ' #
