50 Adjustments and Settings for Recording : Setting the Electronic ShutterThe shutter speed in any shutter mode is set using theSHUTTER switch.In SYNCHRO SCAN mode, shutter speed can be switchedeasily, using the synchro-scan adjustment switches (+/–)on the side panel.Note that the range of selectable shutter speeds may bepre-defined; whether or not to use the SYNCHRO SCANmode may be determined through the SPEED> and SELECT> screens. Thesescreens are accessible through the menu on the CAMOPERATION page.The selected shutter speed is retained even if the unit isturned off.1 Press the SHUTTER switch, positioned at [ON],towards [SEL].2 Once more, press the SHUTTER switch towards[SEL]. Repeat this switchover until the desired modeor speed appears in the viewfinder screen.If all modes and speeds are available, the displaychanges in the following order:See [ Viewfinder Screen Status Displays] (page 68).To place the camera-recorder in SYNCHRO SCAN mode,follow the steps below.1 Press the SHUTTER switch positioned at [ON]towards [SEL], to place the camera-recorder inSYNCHRO SCAN mode.2 In the SYNCHRO SCAN mode, it is possible tochange the shutter speed continuously by operatingthe SYNCHRO SCAN (+/–) buttons.3 The shutter speed display in synchro scan mode isswitchable between second indication and angleindication.For details, refer to [SYNCHRO SCAN DISP.] (page172).Setting the Shutter Mode and Speed# < SHUTTER SPEED >SYNCHRO SCAN :ONPOSITION1 :ONPOSITION2 :ONPOSITION3 :ONPOSITION4 :ONPOSITION5 :ONPOSITION6 :ON# < SHUTTER SELECT >POSITION1 SEL :1/100POSITION2 SEL :1/120POSITION3 SEL :1/250POSITION4 SEL :1/500POSITION5 SEL :1/1000POSITION6 SEL :1/2000Viewfinder displays relating to the shutterSHUTTER switchPOSITION1 POSITION2 POSITION3 POSITION4 POSITION5 POSITION6NORMAL modeSYNCHROSCAN modePlacing the Camera-recorder in SYNCHRO SCAN ModeSHUTTER switchSYNCHRO SCAN ADJUSTMENT buttons (+/–)
