20 Parts and their Functions Shooting and Recording/Playback Functions Section14.SAVE ON/OFF switchUsed to select the power supply method for eachoutput section.ON: The output selected through the menu optionSAVE SW is power-saved. This option can befound on the OPTION MODE screen on theSYSTEM SETTING page.OFF: Power saving is canceled.NoteThe ON/OFF switch does not function during record-ing. The ON/OFF status changes after recording iscompleted.15.VIDEO OUT (output signal selector) switchChanges the mode of the signals output through theVIDEO OUT connector.HD SDI : HD SDI signals are output. When thecamera-recorder is in SD mode, SD SDIsignals are output.SD SDI : SD SDI signals are output.VBS Composite video signals are output.16.VIDEO OUT CHARACTER switchThis switch controls the superimposition of charactersonto the video output from the VIDEO OUT connector.ON: Characters are superimposed.OFF: Characters are not superimposed.For types of characters, see [ Settings of signals outputfrom VIDEO OUT connector] (page 80).17.VIDEO OUT (video signal output) connectorThis connector outputs video signals. The videosignals linked to the settings of 15. VIDEO OUTswitch, 16. VIDEO OUT CHARACTOR switch and19.OUTPUT SEL switch are output from here. Formore details, refer to [ Settings of signals output fromVIDEO OUT connector ] (page 80).18.MON OUT (monitor output) connectorUsed to output down-converted (analog composite)signals for the monitor. The video signals linked to thesetting of the OUTPUT SEL switch are output fromhere. Through an internal menu option, the characterscan be superimposed independently of the VIDEOOUT connector. For more information, see [ Settings ofsignals output from MON OUT connector ] (page 81).19.OUTPUT SEL (output signal selection) switchUsed to switch the signals output from the VIDEOOUT and MON OUT connectors.MEM: Video from the camera is output duringrecording or when recording is paused orplayback signals are output from the P2 cardduring playback.CAM: Video from the camera is output constantly.OFF: Video is not output, and the camera-recorderoperates in power-saving mode.Note that the audio output is synchronised with thevideo.For types of video outputs, see [ Settings of signalsoutput from VIDEO OUT connector] (page 80) or[ Settings of signals output from MON OUT connector](page 81).Notesz During recording, this switch does not switch outputsignals before stopping the recording operation.z When CAM is not selected through the RECSIGNAL menu option, the output signals are thesame as for MEM even if the switch is set to CAM.The menu option REC SIGNAL is found in theSYSTEM MODE screen on the SYSTEM SETTINGpage.3435361519242120173325262927301832 312822 2314 161231110 9 812134567
