80 Adjustments and Settings for Recording : Selection of video output signalsThe unit employs the VIDEO OUT connector and the MON OUT connector as connectors for outputting video signals.The signal modes for outputting signals from the VIDEOOUT connector are switched with the VIDEO OUT switch.HD SDI:To output the HD SDI signals. When the camera-recorder is set to the SD mode, SD-SDI signals areoutput.SD SDI:To output the SD SDI signals. (Signals are down-converted in HD mode.)VBS:To output the composite video signals. (Signals aredown-converted in HD mode.)The signals output from the MON OUT connector orVIDEO OUT connector are switched with the OUTPUTSEL switch.However, the switching operation is not acknowledgedduring the recording operation.MEMDuring EE, such as recording, video images takenby the camera are output. Meanwhile, signals onthe P2 card are output during playback.CAMThe camera images are output at all times.OFFNo signal is output from the VIDEO OUT or MONOUT connector.Set the characters to be superimposed on the signalsoutput from the VIDEO OUT connector by using theVIDEO OUT CHARACTER switch and the OUTPUT ITEMitem on the menu ( SEL> screen on theSYSTEM SETTING page).Selection of video output signalsSettings of signals output from VIDEO OUT connectorVIDEO OUT switchOUTPUT SEL switchVIDEO OUT CHARACTERswitchItem Variablerange RemarksOUTPUT ITEM MENUONLYTCSTATUSSet the characters to besuperimposed on the output signalsfrom the VIDEO OUT connector.MENU ONLY:The menu screen is superimposedonly when the menu is accessed.This normally displays nothing.TC:Time codes are superimposed(when the menu is accessed, themenu screen is superimposed.)STATUS:The characters that are the sameas the characters superimposed inthe viewfinder screen aresuperimposed.(When the menu is accessed, themenu screen is superimposed.)
