149Maintenance and Inspections : Warning SystemMaintenance and InspectionsIf a problem is detected immediately after the power is turned on, or during operation, this will be indicated by theWARNING lamp, lamps inside the viewfinder and a warning tone.NoteThe WARNING lamp has the highest priority, followed by the tally lamp, and then the warning tone. When multiple errorsoccur simultaneously a higher priority indication will be triggered. The [WIRELESS RF], however, may not be indicated,depending on the menu setting.Warning SystemWarning Description Tables1. System ErrorsDisplay windowindication The error code lights up.WARNING lamp Blinks 4 times per second.Tally lamp Blinks 4 times per second.Viewfinder The SYSTEM ERROR indication and theerror code light up.Warning tone Beeps continuously.WarningdescriptionAn error in the reference signal or thecommunication.Recording/playbackoperationThe operation stops.Countermeasures Please confirm [Error Codes] (page 152)and consult your distributor.3. Battery EmptyDisplay windowindicationAll 7 bar indicators for battery remainingcapacity start blinking.WARNING lamp Lights up.Tally lamp Blinks once per second.Viewfinder The BATT LED lights up.Warning tone Beeps continuously.Warningdescription The battery has run out.Recording/playbackoperationThe operation stops.Countermeasures Replace the battery.2. Card removal errorDisplay windowindication Error code E-30 blinks.WARNING lamp Blinks 4 times per second.Tally lamp Blinks 4 times per second.Viewfinder The “TURN POWER OFF” indicator lightsup.Warning tone Continues to beep.WarningdescriptionThe P2 card being accessed has beenremoved, resulting in an error in the internalmemory of the camera-recorder.Recording/playbackoperationCannot be performed.CountermeasuresTurn off the power to the camera-recorder. Ifthere is an error in a clip on the removed P2card, repair the clip.4. Write-protectDisplay windowindicationAll 7 bar indicators for remaining MEDIAcapacity start blinking.WARNING lamp This lamp will illuminate continuously until anoperation is made after recording.Tally lamp This lamp will flash 4 times every seconduntil an operation is made after recording.Viewfinder The WP indicator lights up.Warning tone This tone will sound continuously until anoperation is made after recording.Warningdescription The inserted P2 cards are write-protected.Recording/playbackoperationRecording is disabled.Countermeasures Disable the write-protect or replace the P2card.
