Panasonic AG-MD830E Service Manual

......oOPERATING INSTRUCTIONSTroubleshootingCheck out the points in the table given below, and consult w~h your dealer if the trouble should persist.TroubleNo powerNo operation even when anoperation button is pressedNo recordingNoise appears on playbackpictures.No repeat playbackNo VISS signal writingError DisplayCheckpoint/Remedial Action• Has the power cable been connected?• Is the power switch in the ON position?• Has a cassette tape been loaded?• Is" d" displayed indicating condensation lighted?Keep the power supplied to the unit and wait until the" d " indisplay goes off.• Is the Mode Lock Switch at the OFF position?• Has the tape's accidental erasure prevention tab beenbroken out?• Has the INPUT Selector been set to the proper position?• Press the Tracking Buttons and adjust.• Has the MEMORY (MEMO) Button been set to the proper position?• Has the counter been reset?• Is the VISS setting on the menu screen at OFF?• Has an interval of at least 20 seconds been given betweenBEGIN and END?• Is the VISS setting on the menu screen at REC orREC/PAUSE?• Has an interval of at least 30 seconds been given betweenone VISS and another VISS signal?ReI. PageE-19E-15E-14E-15, E-16E-11E-11E-9E-13E-9E-12The following error messages will be displayed on the tape counter if an abnormality occurs in the unit. In this case, followinstructions described below.• When an error code appears:• An error code appears on the display.• All operations are shut down when an error code appears on the display.• If the error is not released even after taking the remedial action described below, switch off the power, disconnect the powercable from the power outlet, and contact your dealer immediately.• List of error codesError Code Malfunction Remedial actionE- C' Malfunction in elevator These errors may occur if the videosection cassette has not been loadedproperly.E- :1 Malfunction in loading Try switching the power off and-, section turning it back on again.E- ,-, Malfunction in cylinder These errors may occur if there is, section something wrong with the state ofC -C Malfunction in reel section the video cassette. Try switching the!.. -, power off and turning it back onE-b Incorrect tape tension again and replacing the videocassette.E- -, Malfunction in solenoid Try switching the power off and, turning it back on again.- E-20-