Panasonic AG-MD830E Service Manual

:2!Cl)z«:::I:()w:E3-7-5. ASSEMBLY PROCEDURES OFCENTER GEAR1. Softly Install the Center Gear onto the RetainerGear so that the two holes in the Center Gearalign with the holes on the Retainer Gear, theninstall the cut washer as shown in Figure M43.CAPSTANMOTOR CENTER GEARLOADING CAMGEARTHROUGHT HOLE I CENTER GEARWZl ~.r'WZl,~- RETAINER GEAR~RING GEARCHASSISFigure M433-7-6. ASSEMBLY PROCEDURES OFMAIN LEVER AND CAMFOLLOWER ARM UNIT1. Install the Main Rod and then insert the cutwashers as shown in Figure M44.2. Install the Cam Follower Arm so that the pin ofthe Cam Follower Arm inserts into the groove ofthe Main Cam Gear and also inserts into the sloton the Main Rod, insert the retaining ring.CUT WASHERSFigure M443-7-7. ASSEMBLY PROCEDURES OFLOADING GEAR (T), LOADINGGEAR (S) SECTOR GEAR1. Set the P2 and P3 posts to fully unloadedposition, then install the Loading Gear (T) and(S) so that the outer hole on the Loading Gear(T) aligns with the outer hole on the LoadingGear (S) as shown in Figure M45-A.2. Install the Sector Gear so that the outer hole inthe Sector Gear aligns with the projection markon Loading Gear (T).3. Insert 3 retaining rings as shown in Figure M45-B.SECTOR GEARLOADING GEAR (T) LOADING GEAR (S)Figure M45-ARETAININGr RINGSRETAINING~RINGSI SECTOR GEARFigure M45-B3-30