Panasonic AG-MD830E Service Manual

1:2en3-7-11. ASSEMBLY PROCEDURES OFGEAR BASE UNIT1. Install the Gear Base Unit and screw 4 screws(F) as shown in Figure M49.SCREWS (F)z Figure M49ioe(.::J:u Note: The Gear Base Unit has 2 gears and worm~ shaft. There is no adjustment for these gears.3-6-12. REINSTALLATION OF CASSETTECOMPARTMENTWhen you reinstall the cassette compartment, theposition adjustment of mechanism is necessary forcorrect operation, as follows.A. Confirmation of STOP Alignment Condition1. Turn the Worm shaft counter-clockwise orclockwise until mechanism is placed into theAlignment Condition as following conditions.a) Identification hole on the Mode Select Switchat 6 oclock position and aligned with smallhole on Pinch Cam. (Figure M48)b) P5 Arm is completely loading position andthe I nclined Base (S) and (T) are completelyunloading position.c) Small hole on Sub Cam Gear should alignwith small hole on the Connection Gear(Figure M46) and rectangular mark on theConnection Gear should be at a 3 oclockposition.d) Pressure Roller Unit is UP position.B. Confirmation of Cassette Compartment1. Confirm that the Cassette Compartment isaligned properly. In the EJECT position(Cassette Holder up and advanced to the front)the two V-shaped marks on the slide switchshould align. The slide switch is located on theright side of the Cassette Assembly towards therear as shown in Figure M50A.PHOTO TR. C.B.A.< CASSETTE SWITCH>Figure M50-A2. Remove 3 screws (A) as shown in Figure M50-B.3. Take the top plate out.4. Take the cassette Holder unit out as shown inFigure M50-C.Figure M50-BCASSETTE HOLDER UNITFigure M50-C Removal of Cassette Holder Unit3-32