Panasonic AG-MD830E Service Manual

screwFigure M31-B[When the inclined base is adjust to an arrow direction(B) tape becomes to lower edge.]3. Confirm that tape position P3 post is upper edgeand then tighten screw as shown in Figure M31-B.4. Confirm that waving is occurred between upperside of P3 post and AIC head. If there is wavingadjust the step 2.Note: After adjust inclined base tapeinterchangea-bility and AIC head adjustment must berequired.3-6-9. ADJUSTMENT OF THRUST GAP1. Turn the thrust adjustment screw clockwise to untilthe capstan rotor just separate from the capstanstator whit rotating the capstan rotor by hand.2. Turn the thrust adjustment screw clockwise to 180degrees from paint at step 1.3. Set the 2 oil seal to edge of the capstan housingas shown in Figure M32.OiIsealFigure M323-6-10. ADJUSTMENT OF FG GAP«TOOL»Fine Adj. screwdriverScrewdriverVFK0330Porchase loclly«SPEC» O.16mm ± O.04mm1. Loosen screw (0) and set the Fine Adjustmentscrew driver n the hole on the Capstan Stator Unit.2. Adjust the gap between FG head and the CapstanStator unit.3. After adjustment tighten a screw (0).SCREWSGAP: O.16mm ± O.04mmFigure M33-ANote: After adjust FG head gap. FG output levelconfirmation must be required.Do not touch the surface of rotor and keepany magnetizable material away.CONFIRMATION OF FG OUTPUT LEVEL1. Connect a oscilloscope to TP8009 (CAP FGoutput) on the Video 3 C.B.A.2. Confirm that FG output level is within specificationduring PLAY/REC or PLAY mode.3. If FG output level is out of specification.Readjust the step 1 - 3 of FG GAP Adjustment.30mV to 180mVFigure M33-B3-23::2!enZ::I:()w::2!