User guide Advanced menu99Form length (Forml) The Formlen function allows you to set the basic form length tomeet your requirements. 11 inches are usual in the USA, as op-posed to 12 inches in Europe.Select the Forml menu (2).Setting options: 12 oder 11 InchDefault setting: 12 inches for 220–240 V printers11 nches for 120 V printersThe value defined here is set in all five menus and for all paperpaths. The setting made here is not changed by loading the default(factory) settings by pressing all four function keys; see section Keyfunctions when turning on the printer (page 34).Confirm the setting by pressing the Set (1) key.Automatic gap adjustment(AGA)This function allows you to switch the Automatic Gap Adjustment(AGA) off or on.Select the AGA menu (3).Setting options: Off/OnDefault setting: OnAGA=On: printer checks paper thickness and changes gap adjust-ment if necessary (default). Measurements take place– after power-on– in single sheet mode: for each sheet– in tractor mode: whenever changing the paper path, whenloading paperAGA = Off: selects manual gap adjustment; the value can be set foreach paper source and each of the five menus available.Confirm the setting by pressing the Set (1) key. The printer automat-ically leaves test mode and assumes online mode.Formlen AGAOnlineSetupBack Next21 3 4Formlen=12" *OnlineSetupSet < > Exit21 3 4Formlen AGAOnlineSetupBack Next21 3 4AGA=On *OnlineSetupSet < > Exit21 3 4
