The Menu User guide56Menu configurations Every printer is shipped with factory default settings. Basic settingssuch as emulation, character size, form length etc., which many ap-plications make use of, are set. At the end of this chapter you will finda menu printout (page 90) which shows you the printer’s default set-tings.Your printer allows you to set and use five independent menu con-figurations. If one of your applications for example requires an IBMprinter while another program works better with an EPSON printer,you can set an IBM emulation configuration with the desired set-tings, and set the second configuration as an EPSON emulation.The active menu is always the one you used last. When you switchon the printer for the very first time, menu no. 1 is loaded. Menu no.1 only remains active until you load another menu. The last activemenu is stored even after the printer is switched off and is reloadedautomatically when the printer is switched on again.For example, to change from menu no. 1 to menu no. 3:Press Setup key.Press Menu (1) key.Press Menu (3) key.Now the following message appears in the LC display:Now press the < (2) or > (3) key repeatedly until Load Menu=3 ap-pears.Then select menu no. 3 as the current setting using the Set key (1).The currently active setting is marked with an asterisk (*).If changing menues it is possible that the printer initializes dueto different emulation settings.Online Trac1Tear OnlineSetup21 3 4Adjust PaperwayMenu Char OnlineSetup21 3 4Print MenuBack Next OnlineSetup21 3 4Load Menu=1 *Set < > Exit OnlineSetup21 3 4
