Settings User guide48Selecting characterdensity and fontYou can use the CPI (Character Per Inch) key in setup mode to sel-ect the number of characters per inch to be printed. You can use theFont key to select resident fonts.Press the Setup key, then the Char (4) key.Press the CPI (4) or Font (1) key (in our example, press CPI).Use the < (2) or > (3) key to set the desired character density. Con-firm the selection by pressing the Set (1) key.You can cancel the selection and leave the setting unchanged bypressing the Exit (4) key.If you pressed the Font (1) key, use the < (2) or > (3) key to selectthe desired font. Confirm the selection by pressing the Set (1) key.You can cancel the selection and leave the setting unchanged bypressing the Exit (4) key.Press the Setup key. The printer returns to the initial status.It is also possible to press the Online key. The printer then changesdirectly to online mode.The selection made will not be retained after switching off theprinter. For more details on how to set the character densityand fonts permanently, please refer to the chapter Setting cha-racter density (CPI) (page 64) and Selecting font (Font) (page 63).Adjust PaperwayMenu Char OnlineSetup21 3 4Font CPIOnlineSetup21 3 410 CPI *Set < > Exit OnlineSetup21 3 4ROMAN NLQSet < > Exit OnlineSetup21 3 4Adjust PaperwayMenu Char OnlineSetup21 3 4
