The Menu User guide88Setting and activatingoptions (PapOpt)For setting the optional automatic sheet feeders (ASFs) and optionaltractors; see Paperway (page 5). Also regulates the activation ofASFs and/or optional tractors.Press PapOpt (3) key.Activation of tractors (AutoTra) This parameter only appears if at least one optional tractor is in-stalled. It regulates the activation of tractors when there is no morepaper left in one of them.Press AutoTra (2) key.Use the < (2) or > (3) key to select the desired setting.Setting Options: Off/T1=T2/T1=T2=T3Default Setting: OffIf an optional tractor is not installed, Off is displayed (factory de-fault). If an optional tractor is installed and the Off parameter is acti-vated, only the selected tractor is supported (either via the menu oran ESC sequence). If the selected tractor is out of paper, printingstops.If an optional tractor is installed and you select T1=T2 (standardprinter) or T1=T2=T3 (2T model), the printer will load paper from theother tractor if the selected one is empty. For the 2T model, the se-lection priority is T2–T3–T1, i.e. if the selected T2 is out of paper, theprinter will first try to load paper from T3, then from T1. If the selectedT3 is empty, the printer will first address T1, then T2. If T1 is selectedand empty, first T2, then T3 will be addressed.Confirm the setting by pressing the Set key (1).FFmode PapOptOnlineSetup21 3 4Back NextAutoTra AutoASFOnlineSetup21 3 4Back NextAutoTra=Off *OnlineSetupSet < > Exit21 3 4