User guide Emulations155LC printing Certain professional applications may require unusually large char-acter sizes. Therefore your printer has the possibility of scaling stan-dard size characters up to factor 99 by means of control sequences(LCP*).The Header sequence defines the parameters (e.g. height) once.This definition remains until the printer is switched off.The printable LCP* information is transmitted in an LCP “bracket”(SI).The following character sets (with national characters) are available:The character sets are selected via the following LCP sequenceESC ”P“ ”L“ ”S“ n ESC ”\“. The value of n may range between 01 and02 (as ASCII characters) – see ID column in the above table.To select e.g. the german character set, you must use the followingdata set:The printout of LCP characters can be selected in all of theemulations. Prerequisite: Printer must be in Barcode mode.Note that this printer supports some scalable fonts in the LQ-2170 emulation if a compatible driver is used.* Large Character PrintingID 23 24 40 5B 5C 5D 5E 60 7B 7C 7D 7EUS ASCII 01 # $ @ [ \ ] ? ` { | } ¯GERMAN 02 # $ § Ä Ö Ü ? ` ä ö ü ßASCII ESC P L S 0 1 ESC \hex. 1B 50 4C 53 30 31 1B 5Cdec. 27 80 76 83 48 49 27 92
