2T model User guide52Paper guidingbracketImportant: It is absolutely necessary to mount the paper gui-ding bracket when using the rear tractor. It serves to protectthe mains and interface cables from being damaged by thepaper in the rear tractor.Hook the paper guiding bracket at the bottom ofthe printer as shown in the figure and then raiseit until it clicks into place by exerting gentlepressure.Selecting the reartractorThe rear tractor can be selected either from an application program,the paper path quick selection or via the setup menu. This chapterdescribes the paper path quick selection; for information on how tomake the setting in the Setup menu, refer to Setup mode.Make sure that the printer is in offline mode; press the Online key,if necessary.Press the Park key (1). If fanfold paper is loaded in the printer, it istransported to the tear position. Tear paper will be displayed. Thenpress any key. If a single sheet is loaded in the printer, it will be ejec-ted.Press the Trac3 (4) key to select the rear tractor.If you do not make a selection within 5 seconds, themenu is closed.The printer returns to offline mode.The display alternates between the basic menu and:STOPOffline Trac1Park Load OnlineSetup21 3 4Single Trac1Trac2 Trac3 OnlineSetup21 3 4Load paper fromTrac3 OnlineSetup21 3 4