Advanced menu User guide100Paper handling (Paphand) The Paphand group of menus improves the possibilities for the trou-blefree printing of paper with properties likely to cause problems(perforations etc.) or paper of poor finish.Put the printer into Test mode by pressing the key Online whileswitching on the printer. The display shows ASCII80 ASCII136.Change to the parameter group Formlen AGA by pressing the keyNext three times.Select the Paphand menu (1).Select the Head up menu (2).Increasing the printhead gap(Head up)With this function you can increase the printhead gap before and af-ter the perforation of the form.Setting options: On/OffDefault setting: OffIf the parameter is set to On, the printhead gap increases duringform feed and line feed four lines before and after the perforation onthe form (= protected zone). The printhead gap is always increasedduring form feeding past the perforation even when feeding takesplace outside the protected zone.Printing is possible in the protected area.Confirm the setting by pressing the Set (1) key.Paphand CX-bidOnlineSetupBack Next21 3 4Head up PagewidOnlineSetupBack Next21 3 4Head up=Off *OnlineSetupSet < > Exit21 3 412234561 Top edge of form 4 Form separation perforation2 Paper transport strip 5 Protected zone3 Bottom edge of form 6 Transport holes