X e ro x 4 5 95 Co p ie r/ P rin t er S y s te m Ad m i ni s t rat i on G ui d e5-2 45. U s i ng t h e S c an S e rv i c eConfiguration of the Job FlowThis section describes the configuration procedure to use the jobflow scan function on the machine.The following is the procedure to use the job flow scan function:• Enabling the port and setting TCP/IPEnable the SOAP port, SNMP port, and Internet service port,and set IP addresses on the machine.• Configuring the SNMP portConfigure the transport protocol for the SNMP port usingCentreWare Internet Services.• Configuring the computerEnabling the ports and setting the IP addressesIn order to use the job flow service, enable the SOAP port, SNMPport, and Internet service port, and set IP addresses. Theprocedure for setting the machine follows.NOTE: The configuration can also be performed usingCentreWare Internet Services.Refer to“Using CentreWare Internet Services” on page 3-1.1. Display the System Administrator Menu screen.a. Press the Log In/Out button.b. Enter the UserID using the numeric keypad and thenselect Confirm.NOTE: The default User ID value is 11111. When using theAuthentication feature, a password is required. The defaultpassword is x-admin.c. Select System Settings.2. Enable the SOAP port.a. Select System Settings.b. Select Network Settings.c. Select Port Settings.d. Select SOAP and then select Change Settings.e. Select SOAP - Port and select Change Settings.f. Select Enable and then select Save.g. Select Close.