X ero x 4 5 95 Co pi e r/P ri n te r S y s t em Ad m i ni s t rat i on G ui d e 8-1078 . S e t ups• For Bottom Left, you can set the horizontal position within arange of 0-100 in 1 mm increments, and in the vertical positionwithin a range of 0-100 in 1 mm increments• For Bottom Center, you can set the horizontal position withina range of 0-100 in 1 mm increments, and in the verticalposition within a range of 0-200 in 1 mm increments• For Bottom Right, you can set the horizontal position within arange of 0-100 in 1 mm increments, and in the vertical positionwithin a range of 0-100 in 1 mm incrementsUse the following procedure for selecting the default setting foreach of the stamp positions.1. From the Copy Control screen, select one of the AdjustStamp - Top Left, and select Change Settings.2. Set the numeric value using s and t.3. Select Save.Stamp Position-Top Center This feature allows you to fine tune exactly where on the topcenter of the output that your stamp is printed. The selectionmade here becomes the default setting when Top Center isselected for the Stamp Position on the Annotation screen(Output Format tab).Set the position in the horizontal direction within the range 0-100and in the vertical position within the range 0-200 in 1 mmincrements.Stamp Position-Top Right This feature allows you to fine tune exactly where on the top rightof the output that your stamp is printed. The selection made herebecomes the default setting when Top Right is selected for theStamp Position on the Annotation screen (Output Format tab).Set the position in the horizontal direction within the range 0-100and in the vertical position within the range 0-100 in 1 mmincrements.
