X e ro x 4 5 95 Co p ie r/ P rin t er S y s te m Ad m i ni s t rat i on G ui d e4-44. E -m a i l2. Enable the ports which are used for the e-mail feature.a. Select System Settingsb. Select Network Settings.c. Select Port Settings.d. Enable Send E-Mail - Port setting to use mail print.e. Enable Receive E-Mail - Port setting to use mail print.f. Enable Mail Notice - Port to use mail notice or jobcompletion notice.g. Select Close repeatedly until the Network Settingsscreen is displayed.3. Set the IP address.If the IP address is already set, this step is not necessary.Also, in an environment with DHCP or BOOTP, configure theway to obtain the address. If the address cannot be obtainedautomatically or manual configuration is preferred, configurethe IP address, subnet mask, and gateway address.a. Select Close repeatedly until the Network Settingsscreen is displayed.b. Select Protocol Settings.c. Select TCP/IP - Get IP Address and select ChangeSettings.d. Select one from DHCP, BOOTP, RARP, DHCP/Autonet orManual. If you select anything other than Manual, proceedto step 4.NOTE: When using a DHCP server, also configure theWINS (Windows Internet Name Service) server.e. Select TCP/IP - Get IP Address and select ChangeSettings.f. Enter the IP address using the numeric keypad.
