X e ro x 4 5 95 Co p ie r/ P rin t er S y s te m Ad m i ni s t rat i on G ui d e8-1 2 68. S e tu psscreen.NOTE 1: When a port is set to Disabled, the correspondingitems that are associated with that port do not appear.NOTE 2: Depending on the amount of data sent from theclient, increasing the memory capacity may not change theamount of time that it takes to release the client.PostScript Memory Specify the memory capacity used for PostScript. Set a valuefrom 8.00-96.00 MB, in 0.25 MB increments.HP-GL/2 Auto LayoutMemorySpecify the memory capacity used for HP-GL/2. Set a value from64-5120 KB, in 32 KB increments.NOTE: The maximum value that can be set for both the PostScriptMemory and HP-GL/2 Auto Layout Memory options varyaccording to the available memory capacity.Receiving Buffer - LPDSpool• Off: When Off is selected, the machine will not use spooling.During the LPD print process for one client, data cannot bereceived over that same interface from a different client. Set avalue for the dedicated LPD receiving buffer memory capacityfrom 1024-2048 KB, in 32 KB increments.• Memory Spool: When selected, the machine will usespooling. The receiving buffer for spooling uses memory.When this candidate value is selected, set the memorycapacity of the receiving buffer for spooling, from 0.50 MB to32.00 MB, in 0.25 MB increments.NOTE: Notice that print data exceeding the set memorycapacity is not accepted. In such cases, select Hard Disk orOff.• Hard Disk Spool: When selected, the machine will usespooling. The receiving buffer for spooling uses the hard disk.Receiving Buffer - NetWare Set the NetWare receiving buffer. Set a value from 64 to 1024 KB,in 32 KB increments.Receiving Buffer - SMBSpool• Off: When Off is selected, the machine will not use spooling.While SMB print processing is being carried out for one client,data cannot be received over the same interface from anotherclient.Set a value for the dedicated SMB receiving buffer memorycapacity from 64 to 1024 KB, in 32 KB increments.• Memory Spool: When selected, the machine will usespooling. The receiving buffer for spooling uses memory.When this candidate value is selected, set the memorycapacity of the receiving buffer for spooling from 0.50 MB to32.00 MB, in 0.25 MB increments.
