X e ro x 4 5 95 Co p ie r/ P rin t er S y s te m Ad m i ni s t rat i on G ui d e8-1 0 68. S e tu psStamp Position defaultsYou can select the default position that the stamp is printed on theoutput when the Stamp feature is selected on the Annotationscreen (Output Format tab). There are nine stamp positiondefaults:• Stamp Position - Top Left• Stamp Position - Top Center• Stamp Position - Top Right• Stamp Position - Left Center• Stamp Position - Center• Stamp Position - Right Center• Stamp Position - Bottom Left• Stamp Position - Bottom Center• Stamp Position - Bottom RightSelect a setting for each one of these stamp positions. When youselect a specific Stamp Position on the Annotation screen(Output Format tab), such as Top Left, the setting selected heredefines exactly where on the top left of the output the stamp isprinted.You can fine tune the default stamp position in both the horizontaland vertical directions:• For Top Left, you can set the horizontal position within a rangeof 0-100 in 1 mm increments, and in the vertical position withina range of 0-100 in 1 mm increments.• For Top Center, you can set the horizontal position within arange of 0-100 in 1 mm increments, and in the vertical positionwithin a range of 0-200 in 1 mm increments• For Top Right, you can set the horizontal position within arange of 0-100 in 1 mm increments, and in the vertical positionwithin a range of 0-100 in 1 mm increments• For Left Center, you can set the horizontal position within arange of 0-200 in 1 mm increments, and in the vertical positionwithin a range of 0-100 in 1 mm increments• For Center, you can set the horizontal position within a rangeof 0-200 in 1 mm increments, and in the vertical position withina range of 0-200 in 1 mm increments• For Right Center, you can set the horizontal position within arange of 0-200 in 1 mm increments, and in the vertical positionwithin a range of 0-100 in 1 mm increments