X e ro x 4 5 95 Co p ie r/ P rin t er S y s te m Ad m i ni s t rat i on G ui d e2-1 02. C on f ig u rat i onConfiguration on the machineThis section describes the configuration procedure to enableInternet Printing (IPP) on the machine. First enable the IPP port,then set the IP address.NOTE 1: The configuration can also be performed using IPconfiguration tools included in CentreWare Internet Services orCentreWare Utilities.NOTE 2: Enable the SOAP port and the SNMP port in most cases.Refer to “Using CentreWare Internet Services” on page 3-1.1. Display the System Administrator Menu screen.a. Press the Log In/Out button.b. Enter the UserID using the numeric keypad and selectConfirm.NOTE: The default User ID value is 11111. When using theAuthentication feature, a password is required. The defaultpassword is x-admin.c. Select System Settings.2. Enable the IPP port.a. Select System Settings.b. Select Network Settings.c. Select Port Settings.d. Select IPP and then select Change Settings.e. Select IPP - Port and select Change Settings.f. Select Enable and then select Save.3. Set the IP address.If the IP address is already set, this step is not necessary.Also, in an environment with DHCP or BOOTP, configure theway to obtain the address. If the address cannot be obtainedautomatically or manual configuration is preferred, configurethe IP address, subnet mask, and gateway address.a. Select Close repeatedly until the Network Settingsscreen is displayed.b. Select Protocol Settings.c. Select TCP/IP - Get IP Address and select ChangeSettings.d. Select one from DHCP, BOOTP, RARP, DHCP/Autonet orManual. If you select anything other than Manual, proceedto step 4.NOTE: When using a DHCP server, also configure the WINS(Windows Internet Name Service) server.
