No. Name Description Range Def. Mode Addr.Hex Pg.V/fo4-09 IGBTMaintenanceSettingSets the value of the IGBT Maintenance monitorU4-07. 0 to 150 0% O 525 —o4-11 U2 InitializeSelectionSelects if U2-oo (Fault Trace) monitors are reset atdrive initialization.0: Saves the fault monitor data1: Resets the fault monitor data0, 1 0 O 510 —<12> Default setting value is dependent on parameter o2-04, Drive Model Selection.<22> Parameter can be changed during run.<61> Valid for drive software 1011 and later. Value is set in 1 h units for older software.u U: MonitorsMonitor parameters allow the user to view drive status, fault information, and otherinformation about drive operation.No. Name Description AnalogOutput Level Unit Mode Addr.HexV/fU1: Operation Status MonitorsUse U1 monitors to display the operation status of the drive.U1-01 FrequencyReference Monitors the frequency 10 V: Maxfrequency 0.01Hz O 40U1-02 OutputFrequency Displays the output frequency. Display units aredetermined by o1-03. 10 V: Maxfrequency 0.01Hz O 41U1-03 OutputCurrent Displays the output current. 10 V: Driverated current 0.01A O 42U1-06 OutputVoltageReference Displays the output voltage. 10 V: 200 Vrms(400 Vrms) 0.1 V O 45U1-07 DC BusVoltage Displays the DC bus voltage. 10 V: 400 V (800V) 1 V O 46U1-10 Input TerminalStatusDisplays the input terminal status.Digital input terminalS1 enabledDigital input terminalS2 enabledDigital input terminalS3 enabledDigital input terminalS4 enabledDigital input terminalS5 enabledNo output signalavailable – O 49B.2 Parameter Table216 YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
