Drive Ready Signal ............................................................. 674. START-UP PROGRAMMING & OPERATION ............ 694.1 Section Safety.................................................................. 704.2 Using the Digital LED Operator........................................ 73Keys, Displays, and LEDs..................................................... 73Digital Text Display ............................................................. 74LED Screen Displays........................................................... 75LO/RE LED and RUN LED Indications .................................... 75Menu Structure for Digital LED Operator.................................. 774.3 The Drive and Programming Modes ................................ 78Navigating the Drive and Programming Modes.......................... 78Changing Parameter Settings or Values .................................. 82Verifying Parameter Changes: Verify Menu .............................. 83Switching Between LOCAL and REMOTE................................ 84Parameters Available in the Setup Group................................. 854.4 Start-up Flowcharts ......................................................... 86Flowchart: Basic Start-up and Motor Tuning ............................. 864.5 Basic Operation ............................................................... 87Initialize Parameter Values: A1-03.......................................... 87Frequency Reference Source: b1-01....................................... 87Run Command Input Selection: b1-02 ..................................... 89Stopping Method Selection: b1-03 .......................................... 91Acceleration/Deceleration: C1-01 to C1-04............................... 92Drive Duty Mode and Carrier Frequency Selection: C6-01 andC6-02.............................................................................. 93Multi-Step Speed Operation (4-Step Speed) ............................. 96Drive Input Voltage Setting: E1-01.......................................... 99V/f Pattern Settings: E1-04 to E1-10 ..................................... 100Motor Parameters: E2-01 to E2-03 ....................................... 103Digital Output: H2-01 ......................................................... 103Analog Outputs: H4-01 to H4-03 .......................................... 104Motor Protection: L1-01 and L1-02 ....................................... 105Notes on Controlling the Brake for the Hoist Application............ 108Drive Status Monitors: U1-01 to U4-13 .................................. 1094.6 Powering Up the Drive ....................................................111Powering Up the Drive and Operation Status Display ............... 111Table of ContentsYASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual 5
