Table 4.1 Keys and Displays on the LED OperatorNo. Display Name Function1 Data Display Area Displays the frequency reference, parameter number, etc.2 ESC Key Returns to the previous menu.3 RESET Key Moves the cursor to the right.Resets the drive to clear a fault situation.4 RUN Key Starts the drive.5 Up Arrow Key Scrolls up to select parameter numbers, setting values, etc.6 Down Arrow Key Scrolls down to select parameter numbers, setting values, etc.7 STOP STOP KeyStops the drive.Note: Stop priority circuit. A fast-stop is available by pressing theSTOP key when the drive detects a danger even if the drive isrunning by a signal from the multi-function contact input terminal(REMOTE is set). To avoid stoppage by using the STOP key, seto2-02 (STOP Key Function Selection) to 0 (Disabled).8 ENTER Key Selects all modes, parameters, settings, etc.Selects a menu item to move from one display screen to the next.9 LO/RE Selection Key Switches drive control between the operator (LOCAL) and thecontrol circuit terminals (REMOTE).Note: LOCAL/REMOTE key effective during stop in drive mode.10 RUN Light Lit while the drive is operating the motor.11 LO/RE Light Lit while the operator (LOCAL) is selected to run the drive.12 ALM LED LightRefer to LED Screen Displays on page 75.13 REV LED Light14 DRV LED Light15 FOUT LED Lightu Digital Text DisplayText appears on the LED Operator as shown below. This section explains the meaning of textas it appears on the display screen.Lit Flashing4.2 Using the Digital LED Operator74 YASKAWA ELECTRIC TOEP C710606 25B YASKAWA AC Drive J1000 Installation & Start-Up Manual
