5. In order to check whether a connection between the programming device and thecontrol can be established with the selected communication settings, click on ‘Verifyconnection’ .ð You can see in the status line, whether the connection could be established suc-cessfully.6. In order to check whether your programming device is connected with the correctcontrol, you can retrieve information from the connected control. For this click on‘Accessible partners’ .ð The ‘Search for accessible partners’ dialog window will open.7.7.3.4 Server configurationHere you can create the OPC UA configurations.1. Click in the project tree at ‘Device properties’ .ð The editor of the ‘Device properties’ opens.2. Select the area ‘Server configuration’ .You can create a maximum of two OPC UA configurations: One configuration for the CPUand one configuration for the CP (if exists).1. Click at on ‘Add Server’ .ð A new OPC UA configuration is created and listed in the project tree.2. Click in the selection field ‘Active server CP’ or ‘Active server CP’ and choosewhich configuration is to be assigned. With the selection ‘None’ the configurationremains saved in the project. However, it is not transferred to the device.To swap the two configurations for CP and CPU, click on the button .You can create a maximum of two OPC UA configurations.Right-click on the OPC UA configuration (PLC) in the project tree and select‘Remove OPC UA server’.7.7.4 Server settings - ConnectionHere you can perform the connection settings of the OPC UA server.1. Under Project tree at ‘OPC UA configuration’ click on ‘Server settings’ .ð The ‘Server settings editor’ editor opens.2. Select the area ‘Connection’ .Create configurationRemove serverVIPA System SLIO Deployment OPC UAUsage OPC UA Configurator > Server settings - ConnectionHB300 | CPU | 013-CCF0R00 | en | 19-30 203
