13.6 TIA Portal - Deployment PG/OP communication - PROFINET– With firmware version V2.4.0, there is a PROFINET IO controlleravailable via the Ethernet PG/OP channel.– As soon as you use the PROFINET functionality via the EthernetPG/OP channel, this affects the performance and response time ofyour system and due to the system the cycle time of the OB 1 isextended by 2ms.13.6.1 Deployment as PROFINET IO controller13.6.1.1 Steps of configurationRange of functionsPlease regard that the PROFINET IO controller supports only thePROFINET functions, which are described in this manual, even if the Sie-mens CPU, which is used for configuration, offers further functions! Touse some described PROFINET functions, it is necessary to deployanother Siemens CPU for configuration. Here, however, is pointed toexplicitly.The configuration of the PROFINET IO controller for PROFINET communication shouldbe done by the following procedure:1. Commissioning and Initialization (assignment IP address data)2. Hardware configuration - CPU3. Configuration PROFINET IO controller4. Configuration PROFINET IO deviceWith the Siemens TIA Portal, the CPU 013-CCF0R00 from VIPA is to beconfigured asCPU 314C-2 PN/DP (314-6EH04-0AB0 V3.3)!13.6.1.2 Commissioning and initialization1. Install your System SLIO with your CPU.2. Wire the system by connecting cables for voltage supply and signals3. Connect your PROFINET IO controller with Ethernet.4. Switch on the power supply.ð After a short boot time, the CP is in idle.At the first commissioning respectively after an overall reset of the CPU, thePROFINET IO controller and the Ethernet PG/OP channel have no IP address.Assembly and commis-sioningVIPA System SLIO Configuration with TIA PortalTIA Portal - Deployment PG/OP communication - PROFINET > Deployment as PROFINET IO controllerHB300 | CPU | 013-CCF0R00 | en | 19-30 305
