5. Save, compile and transfer your project.13.7.5 Deployment as PROFIBUS DP slaveThe following section describes how to use the PROFIBUS part as an "intelligent" DPslave on master systems. Execute the following steps:1. Configure a station with a CPU with DP master mode.2. Network with PROFIBUS3. Configure another station with a CPU with DP slave operating mode.4. Network with PROFIBUS and assign the DP slave to the DP master.5. Configure the I/O areas for the slave part.ð The configuration is automatically adapted to the DP master.6. Save, translate and transfer the respective project into the corresponding master orslave CPU.1. Start the Siemens TIA Portal and configure a CPU.2. Designate the station as "... DP master".3. Integrate the modules according to the hardware configuration of the mastersystem.4. Select the PROFIBUS interface of the master CPU and select ‘Context menuè Properties’.ð The ‘Properties’ dialog is shown.5. Set at interface: Type "PROFIBUS".6. Connect to PROFIBUS and preset an address (e.g. 2).7. Switch at Operating mode to "DP master".Fast introductionConfiguration of themaster partVIPA System SLIOConfiguration with TIA PortalTIA Portal - Option: Deployment PROFIBUS communication > Deployment as PROFIBUS DP slaveHB300 | CPU | 013-CCF0R00 | en | 19-30318
