[1] 1./last bus participant[2] further participantsCAUTION!The terminating resistor is only effective, if the connector is installed at abus participant and the bus participant is connected to a power supply.The tightening torque of the screws to fix the connector to a device mustnot exceed 0.02Nm!A complete description of installation and deployment of the terminatingresistors is delivered with the connector.1. Loosen the screw.2. Lift contact-cover.3. Insert both wires into the ducts provided (watch for the correct line colour as below!)4. Please take care not to cause a short circuit between screen and data lines!5. Close the contact cover.6. Tighten screw (max. tightening torque 0.08Nm).The green line must be connected to A, the red line to B!11.8 Commissioning and Start-up behaviorIn delivery the CPU is overall reset. The PROFIBUS part is deactivated and its LEDs areoff after Power ON.WiringAssemblyStart-up on deliveryVIPA System SLIO Option: Deployment PROFIBUS communicationCommissioning and Start-up behaviorHB300 | CPU | 013-CCF0R00 | en | 19-30 265
