5. To transfer the user program and hardware configuration click in the Project tree atyour CPU and select ‘Context menu è Transfer all’.ð A dialog window for project transfer opens6. Select the ‘Port type’ "Serial interface" and start the transfer with ‘Transfer’ .7. Confirm the request that the CPU is to be brought into the state STOP.ð The user program and the hardware configuration are transferred via MPI to theCPU.8. Close after transmission the dialog.9. With ‘Context menu è Copy RAM to ROM’ you can save your project on a memorycard, if one is plugged.12.9.2 Transfer via EthernetFor transfer via Ethernet the CPU has an Ethernet PG/OP channel. For online access tothis, you have to assign IP address parameters to this by means of "initialization" andtransfer them into your project. For the transfer, connect, if not already done, the EthernetPG/OP channel jack to your Ethernet. The connection happens via an integrated 2-portswitch (X1, X2).1. Switch-ON the power supply of your CPU and start the SPEED7 Studio with yourproject.2. Set at ‘Active PC interface’ the "Ethernet interface".3. Click in the ‘Project tree’ to your project and select ‘Context menu è Recompile’.ð Your project will be translated and prepared for transmission.Proceeding transfer viaEthernetVIPA System SLIO Configuration with VIPA SPEED7 StudioSPEED7 Studio - Project transfer > Transfer via EthernetHB300 | CPU | 013-CCF0R00 | en | 19-30 291
