4 Deployment CPU 013-CCF0R004.1 Please note!The following descriptions always refer to the usage in the SiemensSIMATIC Manager. Information on usage in the VIPA SPEED7 Studio orSiemens TIA Portal can be found here:Ä Chap. 12 ‘Configuration with VIPA SPEED7 Studio’ page 267Ä Chap. 13 ‘Configuration with TIA Portal’ page 2944.2 AssemblyInformation about assembly and cablingÄ Chap. 2 ‘Basics andmounting’ page 12.4.3 Start-up behaviorn The CPU checks whether a project AUTOLOAD.WLD exists on the memory card. Ifso, an overall reset is executed and the project is automatically loaded from thememory card.n The CPU checks whether a command file with the name VIPA_CMD.MMC exists onthe memory card. If so the command file is loaded from the memory card and thecommands are executed.n After PowerON and CPU STOP the CPU checks if there is a *.pkb file (firmware file)on the memory card. If so, this is shown by the CPU by blinking LEDs and the firm-ware may be installed by an update request.Ä Chap. 4.14 ‘Firmware update’page 106n The CPU checks if a previously activated VSC is inserted. If not, the SF LED gets onand a diagnostics entry is released. The CPU switches to STOP after 72 hours. Witha just installed VSC activated functions remain activated.Ä Chap. 4.20 ‘Diagnosticentries’ page 117After this the CPU switches to the operating mode, which is set on the operating modeswitch.In the delivery state the CPU is overall reset. After a STOP®RUN transition the CPUswitches to RUN without program.Turn on power supplyDelivery stateVIPA System SLIODeployment CPU 013-CCF0R00Start-up behaviorHB300 | CPU | 013-CCF0R00 | en | 19-3066
