PERIODIC MAINTENANCE3-26WARNINGEWA13040• If coolant splashes in your eyes, thorough-ly wash them with water and consult a doc-tor.• If coolant splashes on your clothes, quicklywash it away with water and then with soapand water.• If coolant is swallowed, induce vomitingand get immediate medical attention.NOTICEECA13480• Adding water instead of coolant lowers theantifreeze content of the coolant. If water isused instead of coolant check, and if nec-essary, correct the antifreeze concentra-tion of the coolant.• Use only distilled water. However, if dis-tilled water is not available, soft water maybe used.• If coolant comes into contact with paintedsurfaces, immediately wash them with wa-ter.• Do not mix different types of antifreeze.10.Install:• Radiator cap “1”• Radiator cap bolt “2”TIPAlign the hole “a” in the radiator cap with the hole“b” in the radiator.11.Fill:• Coolant reservoir(with the recommended coolant to the maxi-mum level mark “a”)12.Install:• Coolant reservoir cap13.Start the engine, warm it up for several min-utes, and then turn it off.14.Check:• Coolant levelRefer to “CHECKING THE COOLANT LEV-EL” on page 3-24.TIPBefore checking the coolant level, wait a fewminutes until the coolant has settled.EAS30814CHECKING THE FRONT BRAKE LIGHTSWITCHRefer to “CHECKING THE SWITCHES” onpage 8-123.EAS30659ADJUSTING THE REAR BRAKE LIGHTSWITCHTIPThe rear brake light switch is operated by move-ment of the brake pedal. The rear brake lightswitch is properly adjusted when the brake lightcomes on just before the braking effect starts.1. Check:• Rear brake light operation timingIncorrect → Adjust.2. Adjust:• Rear brake light operation timing▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼a. Hold the main body “1” of the rear brake lightswitch so that it does not rotate and turn theadjusting nut “2” in direction “a” or “b” until therear brake light comes on at the proper time.T R..Radiator cap bolt1.0 Nm (0.10 m·kgf, 0.72 ft·lbf)12abDirection “a”Brake light comes on sooner.Direction “b”Brake light comes on later.a