Yamaha 2014 MT-07 Service Manual

REAR WHEEL4-33TIP• Install the rear wheel with the mark “a” on therear tire pointing in the direction of wheel rota-tion.• Align the projection “b” in the swingarm with theslot “c” of the brake caliper bracket.• Make sure that the arrow mark “d” on eachchain puller points upward.• Make sure that the arrow mark “e” on eachswingarm end plate points upward.6. Install:• Rear brake caliper• Rear brake caliper retaining bolt• Rear brake caliper bolt7. Fit the space “a” between the side plates ofthe drive chain “1” onto the rib “b” on the drivechain guide “2”.8. Adjust:• Drive chain slackRefer to “ADJUSTING THE DRIVE CHAINSLACK” on page 3-17.9. Tighten:• Wheel axle nut• Rear brake caliper retaining bolt• Rear brake caliper boltWARNINGEWA13500Make sure the brake hose is routed properly.10.Install:• Rear wheel sensorNOTICEECA21080Make sure there are no foreign materials inthe rear wheel sensor rotor and rear wheelsensor. Foreign materials cause damage tothe rear wheel sensor rotor and rear wheelsensor.a1cb2d3eDrive chain slack51.0–56.0 mm (2.01–2.20 in)T R. .Wheel axle nut105 Nm (10.5 m·kgf, 76 ft·lbf)Rear brake caliper retaining bolt27 Nm (2.7 m·kgf, 20 ft·lbf)Rear brake caliper bolt22 Nm (2.2 m·kgf, 16 ft·lbf)LOCTITE®T R..Rear wheel sensor bolt7 Nm (0.7 m·kgf, 5.1 ft·lbf)1ba2