Yamaha 2014 MT-07 Service Manual

CLUTCH5-59• Clutch cover gasket “2”• Clutch cover “3”• Clutch cable holder “4”TIP• Align the slit “a” in the impeller shaft with theprojection “b” on the oil pump driven sprocket.• Face the serrations on the clutch pull rod “5”rearward and align the rod with the hole “c” inthe clutch cover.• Make sure that the pull rod teeth and pull levershaft pinion gear are engaged.• Apply locking agent (LOCTITE®) to thethreads of only the clutch cable holder bolts “6”shown in the illustration.• Tighten the bolts in stages and in a crisscrosspattern.8. Connect:• Clutch cable “1”TIP• Install the clutch cable so that the clutch cablelength “a” is 51.6–62.2mm (2.03–2.45 in) asshown in the illustration. In addition, make surethat the vehicle is positioned upright whenmeasuring the clutch cable length.• After installing the clutch cable, bend the pro-jection “b” on the pull lever.9. Adjust:• Clutch lever free playRefer to “ADJUSTING THE CLUTCH LEVERFREE PLAY” on page 3-12.T R..Clutch cover bolt12 Nm (1.2 m·kgf, 8.7 ft·lbf)Clutch cable holder bolt12 Nm (1.2 m·kgf, 8.7 ft·lbf)LOCTITE®Newca b15132LS643Clutch lever free play5.0–10.0 mm (0.20–0.39 in)a 1b 1