Yamaha 2014 MT-07 Service Manual

ELECTRICAL COMPONENTS8-1316. Install:• BatteryRefer to “GENERAL CHASSIS (1)” on page4-1.7. Connect:• Battery leads(to the battery terminals)NOTICEECA13630First, connect the positive battery lead “1”,and then the negative battery lead “2”.8. Check:• Battery terminalsDirt → Clean with a wire brush.Loose connection → Connect properly.9. Lubricate:• Battery terminals10.Install:• Seat bracket• Rider seatRefer to “GENERAL CHASSIS (1)” on page4-1.EAS30553CHECKING THE RELAYSCheck each switch for continuity with the pockettester. If the continuity reading is incorrect, re-place the relay.1. Disconnect the relay from the wire harness.2. Connect the pocket tester (Ω × 1) and battery(12 V) to the relay terminal as shown.Check the relay operation.Out of specification → Replace.Starter relayRelay unit (starting circuit cut-off relay)Relay unit (fuel pump relay)Recommended lubricantDielectric greasePocket tester90890-03112Analog pocket testerYU-03112-C211. Positive battery terminal2. Negative battery terminal3. Positive tester probe4. Negative tester probeRelay operationContinuity(between “3” and “4”)1. Positive battery terminal2. Negative battery terminal3. Positive tester probe4. Negative tester probeResultContinuity(between “3” and “4”)1. Positive battery terminalRRL/W R/W1 234R/W L/W R/B R/LW/LL/W L/Y R/W L/G B/R B/Y Sb/WSbR/W L/W R/B R/LW/LL/W L/Y R/W L/G B/R B/Y Sb/WSb