Description of application and parametersApplication "RTC"Product manual 2CKA001473B9679 │11511.4.61 Additional cooling stage — Cyclic sending of the control value (min)Options: Setting option between 1 - 60 minutesThe current control value used by the device can be cyclically transmitted to the bus.NoteThis parameter is only available when the "Control value type" parameter is seteither on "2-point 1 Bit, Off/On", "2-point 1 Byte, 0/100%", "PI continuous, 0-100%" or "Fan coil".11.4.62 Additional cooling stage — Maximum control value (0 - 255)Options: Setting option between 0 - 255The maximum control value of the PI controller defines the maximum value outputted by thecontroller. If a maximum value under 255 is chosen, the value will not be exceeded, even if thecontroller calculates a higher control value.NoteThis parameter is only available when "Control value type" parameter is seteither on "PI continuous, 0 – 100%", "PI PWM, On/Off“ or "Fan coil".11.4.63 Additional cooling stage — Minimum control value for basic load (0 - 255)Options: Setting option between 0 - 255The minimum control value of the PI controller defines the minimum value output by thecontroller. If a minimum value greater than zero is chosen, the controller will not output a lowervalue, even if it calculates a value that is lower. This parameter can be used to set a basic load,e.g. for operating surface cooling. Even if the controller calculates the control value zero, acooling medium will flow through the cooling area to prevent the floor from heating up. Under"Settings of basic load", it is also possible to define whether this basic load will be permanentlyactive or whether it will be switched by the "Basic load" object.NoteThis parameter is only available when "Control value type" parameter is seteither on "PI continuous, 0 – 100%", "PI PWM, On/Off“ or "Fan coil".
