Description of application and parametersApplication "RTC"Product manual 2CKA001473B9679 │14611.4.5 Fan coil settings for coolingNoteThis parameter is only available if the "Device function" parameter is set oneither "Single device" or "Master device" and the "Control value type" parameteris set on "Fan coil". In addition, the "Control function" parameter must be set oneither "Cooling", "Cooling with additional stage", "Heating and cooling" or"Heating and cooling with additional stages".11.4.1 Fan coil settings cooling - Fan speed level valuesOptions: According to standard values tableSpecify individuallyFor the calculation of the fan speed level from the control value or for the output of a percentagevalue for a specific fan speed level, the fan speed level value table is used. The standard valuetable is the table from the KNX specification. For a deviation the values can be specifiedindividually.11.4.2 Fan coil settings for cooling — Speed level 1 to 5 up to control value (0 to 255) coolingOptions: Setting option between 0 - 255In this parameter, the control values of the controller are assigned to fan speed levels. Thisassignment is used if the fan speed levels are transmitted together with the control values.Note■ These level settings should be adjusted to match the settings in the fan coilactuator.■ Setting the "Control value type" to "Fan coil" in the control parameters is onlyuseful for one of either the basic stage or the additional stage. Setting thebasic and additional stage parameters to fan coil is not useful, since thecontrol of only one fan coil actuator each for heating and cooling issupported.■ The "Fan speed level 4 - 5 up to control value (0 - 255) cooling“ parametersare available only when the "Number of fan speed levels" is set on "5 levels".11.4.3 Fan coil settings for cooling — Fan speed level limit cooling for eco modeOptions: NoYesThis parameter limits the fan speed level when the system is switched to eco mode.
