Description of application and parametersApplication "RTC"Product manual 2CKA001473B9679 │13411.4.18 Alarm functionsNoteThis parameter is only available if the "Device function" parameter is set oneither "Single device" or "Master device".11.4.19 Alarm functions — Condensate water alarmOptions: NoYesIf a fan coil is used, condensation may form during operation as a result of excessive coolingand/or humidity. The associated condensate is typically collected in a container. To protect thecontainer against overflowing, and thus prevent potential damage to devices and/or the building,the container alerts the "Condensation alarm" object (receiving only) that the maximum fill levelhas been exceeded. This causes the controller to switch to a protective mode. This status isindicated by the corresponding icon on devices that have a display. Local operation is blocked.Operation is only possible again after the alarm has been deactivated.NoteThis parameter is only available when the "Control function" parameter is seteither on "Cooling", "Cooling with additional stage", "Heating and cooling" or"Heating and cooling with additional stages".11.4.20 Alarm functions — Dew point alarmOptions: NoYesWhen refrigerating machines are used, dew may appear on the refrigerant supply lines duringoperation as a result of excessive cooling and/or humidity. The dew indicator reports the dewformation via the "Dew point alarm" object (receiving only). This causes the controller to switchto a protective mode. This status is indicated by the corresponding icon on devices that have adisplay. Local operation is blocked. Operation is only possible again after the alarm has beendeactivated.NoteThis parameter is only available when the "Control function" parameter is seteither on "Cooling", "Cooling with additional stage", "Heating and cooling" or"Heating and cooling with additional stages".
