Eaton Power Xpert 9395P-1100/1100 Installation And Operation Manual

Also see for Power Xpert 9395: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

92 Eaton® Power Xpert® 9395P-1200 Installation and Operation Manual 164000500—Rev 11IInnssttaallllaattiioonn CChheecckklliisstto All packing materials and restraints have been removed from each cabinet.o Each cabinet in the UPS system is placed in its installed location.o A cabinet grounding/mounting kit is installed between any cabinets that are bolted together.o All conduits and cables are properly routed to the UPS and any ancillary cabinets.o All power cables are properly sized and terminated.o Battery cables are terminated on E4 (+) and E5 (–).o Battery aux contact signal wiring is connected from the UPS to the battery disconnect.o Battery shunt trip signal wiring is connected from the UPS to the battery disconnect. (OPTIONAL).o LAN and telephone drops are installed.o All telephone and LAN connections have been completed.o A ground conductor is properly installed.o Air conditioning equipment is installed and operating correctly.o The area around the installed UPS system is clean and dust–free. (It is recommended that the UPS beinstalled on a level floor suitable for computer or electronic equipment.)o Adequate workspace exists around the UPS and other cabinets.o Adequate lighting is provided around all UPS equipment.o A 120 Vac service outlet is located within 7.5 meters (25 feet) of the UPS equipment.o The REPO device is mounted in its installed location and its wiring is terminated inside the UPS cabinet.o The normally-closed (NC) Emergency Power-off contact (pins 1 and 2 on TB1) is jumpered if not used.o Alarm relays and building alarms are wired appropriately. (OPTIONAL)o A remote battery disconnect control is mounted in its installed location and its wiring is terminated insidethe UPS and battery cabinet. (OPTIONAL)o Accessories are mounted in installed locations and wiring is terminated inside the UPS cabinet. (OPTIONAL)o The debris shield covering the UPS cabinet ventilation grill is removed.o Startup and operational checks are performed by an authorized Eaton Customer Service Engineer.UPS System Installation