Eaton PowerXL DX-NET-SWD Manual

4 Commissioning4.4 Acyclic data56 DX-NET-SWD 06/13 MN04012009Z-EN www.eaton.com4.4.6.4 SmartWire-DT write response(-) – ErrorThis section shows the various possible device-specific errors that can occurduring communications via the acyclic parameter channel with PROFIBUS-DP.The following table describes the various possible errors that can be con-tained in the SmartWire-DT write response(-).In the case of XSoft-CoDeSys, only error code 54dec (representing the errorslisted above) can be output via function blocks XDPMV1_READ andXDPMV1_WRITE when using a PROFIBUS-DP master.4.4.6.5 SmartWire-DT read response(-) – ErrorThis section shows the various possible device-specific errors that can occurduring communications via the acyclic parameter channel with PROFIBUS-DP.The following table describes the various possible errors that can be con-tained in the SmartWire-DT read response(-).In the case of XSoft-CoDeSys, only error code 54dec (representing the errorslisted above) can be output via function blocks XDPMV1_READ andXDPMV1_WRITE when using a PROFIBUS-DP master.Error Type Failure code DescriptionError_Code_1 A1hex Write error: Only reading allowed for indexes 1 – 3(PKE motor-protective circuit-breaker).Error_Code_1 A2hex DC1 variable frequency drive is not available.Error_Code_1 B0hex There is no valid index.Error_Code_1 B1hex Parameter request block too long.Error_Code_1 B5hex Parameter access temporarily not permissible due to internal processes.￫ For more information, see ￫ Section 4.4.4.2, “Protocol“,page 48.Error Type Failure code DescriptionError_Code_1 A1hex Write error: Only reading allowed for indexes 1 – 3(PKE motor-protective circuit-breaker).Error_Code_1 A2hex DC1 variable frequency drive is not available.Error_Code_1 B0hex There is no valid index.Error_Code_1 B5hex Parameter access temporarily not permissible due to internal processes￫ For more information, see ￫ Section 4.4.4.2, “Protocol“,page 48.￫ Further information on the subject of the “transfer of acyclicdata“, consult manual MN05013002Z-EN, “SmartWire-DT Gate-ways“.